where to solder led wires

[Deadd]

ok i have the xcm chrome case with blue leds, and i can find ANYwhere where to solder down these 3 wires, Keep in mind this controller is a Wired controller and all the instructions i have found the solder points arent the same. I just bought this controller about a week ago so im guessing its the V2 series any help would be much appreciated,

Ps the instuctions i found were helpfull untill it said that the VCC wire went right above the GND, yet there is nothing on the circuit board above that GND solder point.

Thanks

This is the only picture i could find and its wrong compared to my controller

[Deadd]

any help online at all? please until i get this figured out im out of a controller

[Deadd]

Ive tried contacting Extreme-Mods where i bought the controller and they said i have to talk to someone here..... I NEED HELP this is getting to be retarted that ive had the post up for almost 10 days and noone is trying to help. please anyone at all that would know about this?

[UKz TaCtiiKz v2]

i have bought the exact same product for thw wireless v2 controller. if you can get a pic of your motherboard front and back and i will tell you wat u need tyo do. i was confused at first but you need to look at your mother board to see whether it is a v1 or a v2. just send my a pic

[Deadd]

[Deadd]

bump
bump