Rapid fire gear pro install ?s

[coolbaldguy]

I have a v2 type controller. On Page 15 of the install guide it says to "connect the following points to the xcm soft PCB, as shown on picture I,L,N, then cut these 4 traces" So do i need to make the connections H, K, and J? I did make the connections assuming that i needed to. My controller buttons that work are: xbox button (center green), both analog sticks, start,select,Y. The turbo feature does not work. The tilt function seems to be on no matter which position the switch for it is in. This is a difficult install, but i am experienced in electronics and repair, and think i have good solder connections and nice clean cuts of the appropriate traces. I even "uninstalled" and "re-installed" the entire kit. I was thinking of trying to find a v1 controller to try a fresh install with the other PCB that came with the kit. Any help you can give me would be much appreciated. I am willing to take voltage readings at test points or whatever it takes to either trouble shoot or start from scratch. Also, if you have installation available, i would be interested. Also is it possible that there is a problem with the PCB that the ribbon cable connects to? I really think that the install i did is good, and maybe the problem is in the TOP portion that came in the kit. I will keep plugging away at this and will post if i find what i did wrong.

[coolbaldguy]

??????????

[coolbaldguy]

I havnt seen a team xcm post on this forum since 7-17-09 is anyone monitoring this?

[Arbosia]

hey anyone know the best way to get some information on why my right trigger wont stop flickering, fires regularly then a whole bunch of times then normaly without turbo

[TeamXCM]

Its hard to say unless you post some high rez pics of the install. The best thing to do is grab a digital microscope and make 100% sure the traces are cut correctly and none of the traces next to them are severed.

[Arbosia]

i think it has something to do with the chip/transistor/capacitor atached to the ground it had some white stuff around the edges any clue? i know my cuts are perfect i made sure triple time

[TeamXCM]

Make another thread and post some pics of what you are reffering to and i'll take a look. I'm sure it can be fixed one way or another.

[coolbaldguy]

OK... I started again with a new controller, its a V1. Completed the install with the help of a 10x jewelers loupe.I took about 6 hours.The controller works great with the exception of the tilt function. The problem i am having is this, the tilt function only seems to move extremely slow. All of the directions work but it would be as if i was barely moving the left analog stick. Should i be able to check the tilt board with a multimeter? If so which leads would be the signal out of the board?

[TeamXCM]

Sorry i don't have any experience with the tilt boards or functions. Personally i don't see a need for them, but others may decide differently.