Rapid Fire Gear Lite

[DarkxXxShredder]

Hey i am going to install my mod but when i went to do so i noticed that there were 2 v2 yellow chips in the box and i was wondering which of the two i should be using because they are different.

thanks for any help i get

[TeamXCM]

If you could post a pic of them, i can idenfity which one you should use.

[DarkxXxShredder]

heres the pictures hope this can clear things up maybe

[DarkxXxShredder]

Ok well i figured out the last thing
and was able to install the kit however when i turn on the controller the only buttons that seem to work are the Y button and the bumpers and the start and back and home buttons. also the turbo feature will not seem to be activated...ill add some pictures to maybe clarify

[TeamXCM]

The one in the first photo is correct. You'll need to double check all the points to be sure you aren't making any connections that shouldn't be made.

[DarkxXxShredder]

Also none of the LEDS light the old version of the V2 had a k terminal thats not on the new one but it does have a + terminal that I don't Know if or what to hook to

[TeamXCM]

Don't worry the K is not needed on the v2 controller pcb. The main thing you need to focus on is what connections are not being made or which ones are being grounded out on accident.

[DarkxXxShredder]

Alright well i have one other question...where does the upgrade get its power from so that i can properly diagnose the soldering

[TeamXCM]

+5v and GND are the main points that need a connection. Also be sure the +5v is not being grounded to the matrix that provides ground throughout the controller pcb.

[DarkxXxShredder]

I am unsure of where the +5v if you can tell me where it is located that would be a great help.