Rt bumper

juice8 · #1 02-28-2009, 02:36 AM

Hi,

I have the RF pro, I can't figure it out, when I press the Rt bumper it seems that it's stuck. It keeps pressing w/o me pressing it. I didn't set it to rapid fire either. Is there something I missed?

TeamXCM · #2 02-28-2009, 10:25 PM

You'll have to check to see if thw swtich is getting stuck. Does it keep pressing it like its on rapid fire or act like its just pressed down and held down?

juice8 · #3 03-01-2009, 06:13 PM

I checked the button and made sure that it's not stuck. When I use the rt bumper on COD4, it won't throw. I just hold on the grenade till I blow up and when I respawn the same happens, cook the grenade blow up, etc.

TeamXCM · #4 03-01-2009, 10:01 PM

Ok well it sounds like it is being grounded which will cause it to do that. Recheck your soldering and be sure there are no solder bridges or exposed wire where they are making contact. The points are very close together but any connection between them will cause this to happen.

tribbey2007 · #5 03-03-2009, 06:34 PM

hi guys im new to this whole forum this so if my questions doesnt come off right i apologize but i had a few quick questions about this mod i believe i followed the instructions pretty well im using the 360t2 on a cg mb but not the cg with the black chip in the middle its more of a wafer color my problem is that the right and left trigger buttons dont work the turbo when press and sync with a button does nothing and the only thing that seems to light up is the jem in the middle and the start and pause button so if some could plzz help me to figure this out it would be well appreciated and also im alil confused about the cuts between the right and left triggers so some insight on that would be great