Controller Fix Mod Board for v2 PCBs

[TeamXCM]

The Controller Fix Mod Board from XCM is a new component to be used on the wireless controller cases made by XCM. This is only needed for v2 controller PCB's and does not pertain to the XCM Rapid Fire Gear series of controller cases. This mod board will brighten the leds if your leds are not very bright after installing the case. This mod is not required for all v2 controllers, but if you notice the light is really dim on your controller case even when using fresh alkaline batteries, this will solve your problem.

The installation is very easy and can be seen in the help forums on www.TeamXCM.com in the appropriate thread. A preview pic has been attached to this thread.

These should be available at all authorised XCM retailers by the middle of next week. If you require one please contact your dealer to purchase one or arrange for one to be sent to you for only the cost of postage.