ok i have the xcm chrome case with blue leds, and i can find ANYwhere where to solder down these 3 wires, Keep in mind this controller is a Wired controller and all the instructions i have found the solder points arent the same. I just bought this controller about a week ago so im guessing its the V2 series any help would be much appreciated,
Ps the instuctions i found were helpfull untill it said that the VCC wire went right above the GND, yet there is nothing on the circuit board above that GND solder point.
Thanks
This is the only picture i could find and its wrong compared to my controller
